Home > Brew Beer > Brewing Equipment > All Grain Brewing >

Adjustable Clamps for Brewzilla Digiboil BMAG557
Adjustable Clamps for Brewzilla Digiboil
 
Alternative Views:

$15.99

Quantity in Stock:1

Availability:: Subject to availability
Product Code: BMAG557
Qty:

Description
 

Get the exact tension you need with your BrewZilla or DigiBoil with KegLand's Stainless Steel Adjustable Clamp Set. Permanently and easily replace the standard lid clamps and adjust the tension to your needs. These clamps are only intended for use with the metal Distillation Lid or Boiler Extension Kits. If you are having trouble getting the correct tension to form a good seal with those accessories, these adjustable clamps can help you dial in the fit. They should never be used with the standard glass lid.

Compatible with 35L and 65L BrewZillas (Gen 3 / Gen 4), DigiBoils (Gen 1 / Gen 2), and Boiler Extensions.

Installation Instructions:

  1. You will need a pair of bolt cutters or tin snips to cut the standard clamp off. (Please see product photos for optimum cut location).
  2. Remove the nut and bolt and thread it through the clamp. Ensure that the grooved part is facing outwards (photo for reference). If you do not have the grooved part facing outwards, the clamp will be blocked by the round lip of the boiler.
  3. Loosen the bolts and spin the clamp up or down to adjust the tension. Use the nuts to lock the desired tension. It is always best to start looser than you think, then adjust tighter.

Warning: Do not use the adjustable clamps with a glass lid, the clamps are only designed for distillation lids or other metal accessories.

Please note: The adjustable clamps will eventually phase out the standard lid clamps on all Gen 4 BrewZillas. They are not necessary when brewing with the standard glass lid. You should only swap to the adjustable clamps if you are using the metal distillation lid or boiler extensions and are having issues with getting the correct tension when using those accessories.
Features

  • ts.

    • Features:

      • Stainless steel construction
      • 9 gallon total capacity with a finished beer output of 5-6 gallons
      • Digital temperature controller
      • Automatic step mashing with 6 programmable stages
      • 110V power and plug
      • Dual heating elements for total control (1000 watts and 500 watts)
      • Stainless steel 1/2 in ball valve for draining (don't have to use the pump)
      • Immersion wort chiller included
      • Stainless steel malt pipe/basket
      • Stamped volume markers
      • Glass lid
      • Magnetic drive pump for recirculation
      • Recirculation arm
      • Temperature reads in °F or °C (press and hold temp button for several seconds to adjust)
      • 32.75 in H (with recirculation arm) x 12.5 in D
      • Recommended max. grain bill - 18 lbs
      • Recommended min. grain bill - 8 lbs

Share your knowledge of this product. Be the first to write a review »