The Tapcooler Counter Pressure Bottle Filler is the #1 way to fill bottles of your homebrew, directly from your kegging system. No more messing with alternate liquid lines or hard to assemble contraptions. Just fit the Tapcooler into any forward sealing faucet (i.e. Perlick, Intertap/Ultratap/Vent-Matic, etc..), hook up a CO2 line, and you're good to go. Fill bottles for a competition, or just fill a couple take home bottles for your friends. The Tapcooler is quick and easy to use, and will help maintain the flavor, aroma, and carbonation level of your beer so it tastes the same out of the bottle as it would out of the tap.

For starters, a counter pressure bottle filler is better than most bottling solutions, as the bottle is under pressure while the carbonated beer flows in. Because the interior of the bottle is pressurized there is minimal loss of the CO2 in solution.

The Tapcooler solution improves upon the standard counter pressure filler, as it plugs directly into your draft system faucet (tap). Most solutions require you to hook up a separate liquid line, which is not something standard draft systems have setup and requires additional prep (i.e. more time). With the Tapcooler, you can have it setup and ready to go in less than a minute! The Tapcooler design is also advantageous because after you are done filling the bottle, it stays in place hooked up to your faucet vs. other fillers require you to set aside and pick back up again for the next bottle.